T-series Grinder (vertical type)
Y-series Grinder (swing type)
The high-speed multifunctional grinder features are as follows, fine structure, low noise, small size, no vibration, compact appearance and easy operation.
It can grind all kinds of corns and grains into fine powder at 50-300 mesh.
It is widely used in families, clinic, hospital, pharmacy and institute laboratories.
Model NO. |
Grinding Capacity |
Voltage |
Dimension |
150T |
150 |
110/220 |
18X18X35.5 |
300T |
300 |
110/220 |
19.5X19.5X40.5 |
800T |
800 |
110/220 |
19.5X19.5X40.5 |
300Y |
300 |
110/220 |
40X24X28 |
400Y |
400 |
110/220 |
40X24X28 |
500Y |
500 |
110/220 |
40X24X28 |
700Y |
700 |
110/220 |
24.5X24.5X41 |
1000Y |
1000 |
110/220 |
24.5X24.5X41 |
1500Y |
1500 |
110/220 |
24.5X24.5X41 |
2000Y |
2000 |
110/220 |
24.5X24.5X41 |
2500Y |
2500 |
110/220 |
24.5X24.5X41 |
3000Y |
3000 |
110/220 |
32X32X52 |
1. Open the upper cover and put the material inside;
2. Close the upper cover tightly;
3. Plug in and turn on the timer switch, then turn on the switch for grinding (Rolling
sound will be heard );
4. Turn off the switch, (When you hear the sound rolling evenly, the material has been grinded into powder, then you can turn off the switch);
5. Disconnect power supply before opening
6. Open the upper cover and brush the powder out;
1. Disconnect power supply before opening.
2. The spice grinder materials ready for grinding must be dry. And wet, moisture or oil
materials are not suitable to be grinded into powder.
3. Each input material shall not exceed the rated weight or half capacity of crush cabin so
that there is enough space for powder.
4. After switch on, if finding the material is wet or excessive in weight, it will jam the blade
and stop the motor by giving warning noise.
So must plug out immediately to prevent motor from being damaged. And remove the
jammed object. Then restart grinding.
5. The spice grinder grinding work usually needs 30 seconds to 1 or 2minutes. Over time
working will cause bearing overheating.
Parts Change:
Trouble | Cause | Elimination method (*Please turn off the power when doing following) |
Motor not work after power on | 1.poor contact between the plug and socket | 1.repair or change the plug, or socket. |
2.power switch broken | 2.repair the power switch | |
3.air over-load protector protecting | 3.press the air over-load protector,restart. | |
4.carbon brush ware out | 4.change the carbon brush | |
Motor runs slowly, or not runs, even vibrates | 1.stuck inside of crush cabin by material, or foreign subject | 1.remove the stuck stuff |
2.low power voltage | 2.adjust the power voltage | |
Motor cabin over heat | 1.over load capacity | 1.decrease the grinding material,reduce work stress |
2.motor moist | 2.dry the motor | |
3.low power voltage | 3.adjust the power voltage | |
Spark on the carbon brush surface | carbon brush surface not smooth | remove the stuff on the surface |